pennants « SlotCarChitChat.com

Posts Tagged ‘pennants’

Tuesday, March 2nd, 2010

Before beginning assembly apply all decorative stickers called for on the drawing.
Install inner wall 1 in building 2. Make sure the upper corners of the inner wall are inserted between the small tabs at the ends of the longitudinal building brace.
Install the building on base 3 so that the opening in the base lies between the inner and rear walls. Make certain that the lower corners of the inner wall enter between the small centering ribs on the base.
Install awning 4 with its upper edges resting on the framing around the counter window opening. The upper edges of the awning sides snap under the small pin protruding from the sides of the building.
Install upper storey 5 and windows 6.
Install roof 7 and cupola 8.
Cement loud speakers 9 into gutters at the roof corners.
Apply a pennant to pole 10 and then cement the pole into the hole in the cupola.

Friday, February 26th, 2010

Before beginning assembly apply all the decorative stickers called for on the drawing.
Install building 1 on base 2.
Install the left and right hand blinder panels 3 as shown with the small lugs facing downwardly and with the shorter end panel of each blinder next to the door.
Install roof 4.
Apply pennants to poles 5 at the same time determining the location of each pole so that the pennants will all flutter in the same general direction; then cement the poles into the gutters at the roof corners.
Install vents 6.

Thursday, February 25th, 2010

Before beginning assembly apply all the decorative stickers called for on the drawing.
Install building 1 on base 2.
Cement the two turnstiles 3 in place.
Install the four short picket fences 4. Note that there are two left hand and two right hand fences which should be installed as shown in the drawing. Install the two long picket fences 5.
Install roof 6.
Apply pennants to poles on roof signs 7. Determine proper location for each sign then apply the pennants so that they all appear to flutter in the same general direction. Cement the signs to the roof gutters as shown.
Install the loudspeaker 8.

Wednesday, February 24th, 2010

Tuesday, February 23rd, 2010

Before beginning assembly apply all the decorative stickers as called for in the second sketch below.
Install the roof trusses 1 on base 2. There are two left hand trusses and two right hand trusses each of which is molded with its cross members recessed on one side and flush on the opposite. All trusses should be installed with their flush side facing the steps at the center of the base. The trusses are installed as follows: Hold a truss on an angle as shown in the first sketch below, then insert the offset lug at the bottom of the long column between the third and fourth boards from the bottom. Similarly, insert the lug of the middle column between the sixth and seventh boards from the bottom. Then rotate the truss to vertical and carefully slide it into its location allowing the small lug at the bottom of the rear column to drop into its respective hole.
Install roof 3.
Apply pennants to poles of signboard 4 then install the signboard on the roof.
Cement loudspeakers 5 into small loops on signboard. Turn the loudspeakers so that they face slightly away from each other.