- Assemble RELEASE WIRE to RELEASE LEVER (SIMULATED HAY BALE).
- Place RELEASE WIRE and LEVER ASSEMBLY into position of #1 PYLON HALF – then locate COIL SPRING under HAY BALE and onto PEG of PYLON BASE EXTENSION.
- Place PEG on FLAG into HOLE at top of #1 PYLON HALF.
- With FLAG and RELEASE WIRE, LEVER and SPRING in proper position – Place #2 PYLON HALF over #1 PYLON HALF.
- Hold PYLON ASSEMBLY firmly and insert into PYLON BASE. If PYLON is correctly assembled FLAG may be “RAISED” by hand and it will only “DROP” when HAY BALE RELEASE is depressed. When you have made certain that PYLON is correctly assembled and functions properly, PYLON can be cemented to PYLON BASE, being careful not to get any cement near HAY BALE LEVER. It is not necessary to cement PYLON HALVES together and it is advisable not to do so unless extreme care is taken not to get any cement near the FLAG PIVOTS and RELEASE LEVER (HAY BALE).
- Cut out “GUM LABEL” FLAGS and apply to START-FINISH FLAGS on PYLONS.
Posts Tagged ‘1450’
Aurora HO Model 1450-100 Start Finish Pylons Assembly Instructions
Thursday, May 6th, 2010HO Gauge Railroad & Road Racing Structures Box End Panel Graphics
Tuesday, April 27th, 2010Part of the allure to collecting vintage Aurora buildings is the colorful graphics that each box displays. If you are investing in a complete set of these HO 1/87 scaled structures for your railroad & slot car layout you get an added value bonus of looking at a box with colorful artwork & graphics. Listed here again is group III of the vintage HO plastic model accessory scenery kits which were produced along with their original stock numbers and price.
- 1450-1.00 Start & Finish Pylons
- 1451-1.00 HO Scale Judges Stand
- 1452-2.00 HO Scale Grand Stand
- 1453-1.98 Double Station Pit Stop
- 1456-1.49 HO Scale Curved Bleachers
Colorful box artwork is typical for the period and Aurora made no exception as you can see from this image of the side panels.
Aurora HO Slot Car Racing Plastic Model Building Kit Box End Panel Graphics
HO Slot Car Layout Model Motoring 1450-100 Start Finish Pylons Kit
Tuesday, April 20th, 2010The Aurora MoDEL MoToRING start finish pylons kit displays nicely on any HO scale slot car racing track layout because it was scaled specifically to fit 1:87 scale slot car racing layouts. This kit could also fit well on any HO gauge road & rail train layout. This all plastic assembly kit is hard to locate.
Aurora MoDEL MoToRING HO Scale Layout Plastic Start Finish Pylons Kit